Use Dovetail Hardware to make stops and hold-downs that move freely, and tighten down anywhere you can route a groove. The big dovetail clamp Vixen+Losmandy PLUS for EQ6 allow to install on the Skywatcher EQ6 or N-EQ6 mount telescopes with Vixen and Losmandy type dovetail bars. These are values which ideally would be at 0 but as our test optics are all curved lenses, there will always be astigmatism and coma present. You can create a variety of sleds, jigs and fixtures with hold-downs and stops with this Dovetail Track Hardware.

Hardware Pack you can create a variety of sleds, jigs and fixtures with hold downs and stops that can move freely and lock down where needed anywhere you can. Finance is provided by PayPal Credit (a trading name of PayPal UK Ltd, Whittaker House, Whittaker Avenue, Richmond-Upon-Thames, Surrey, United Kingdom, TW9 1EH). Most purchases from business sellers are protected by the Consumer Contract Regulations 2013 which give you the right to cancel the purchase within 14 days after the day you receive the item. When cookies and similar technologies are used, data may also be processed in countries that are not part of the European Economic Area. DIY Dovetail Tracks: With the MatchFit system, you can route your dovetail clamp tracks using a dovetail bit.The MatchFit Rachet Clamp AP comes backed by our 100% Satisfaction Guarantee and Extended 3-Year Warranty. To the eye they look very very similar, but when you attempt to insert the Matchfit clamp into the underside of the Festool track, it goes in partially (almost to the shoulder) and then stops.

Again, these are measured by the interferometer when we take measurements of the optical surface after adjustment. I saw a video where someone tested the pressure needed to pull the clamp through, mdf failed, but ply and hardwood was good. was looking at a t slot cutting router bit, but the depth needed would be too deep - planing on usual 3/4 material, and these need more to have enough timber above the slot to hold a regular track clamp. Keeping to the same quality standards that have made the fully-apochromatic refractors legendary, Roland Christen's company has been building German Equatorial GoTo mounts for more than three decades. The Clamps hold the fence extension securely at the ends of the table saw fence preventing bowing out.Create your own dovetail clamp tracks with any standard 1/2” 14-degree dovetail router bit, eliminating the need for expensive aluminium tracks.

Of course you can also subscribe to our Newsletter to stay informed about new products and releases, special offers and much more. The combined forces keep your workpieces flat and eliminate the need for two or more different clamps.Modell 3" bars and clamps - for Losmandy / Astro Physics (large) / Celestron (large) (Base width of the bar's prism: 76 mm, equals 3".