Using this method it delivers a speedier application than mechanical fasteners, therefore replacing rivets, screws, bolts and spot welds. The heavy-duty bonding tape is viscoelastic in nature, giving foam stress relaxing and energy-absorbing properties – but what does this mean? Avoiding these forces causing failures over time, this happens with mechanical fixings, and leads to further maintenance and increased cost. If you already didn’t need an excuse to use this tape in your industry its durability is further increased by its resistance to solvents, moisture and UV, reducing wear unlike mechanical components, which can be easily corroded. UHB Bonding Tape Sizes ABS - acrylonitrile-butadiene-styrene is an everyday plastic that is widely used today because of its surface hardness, high impact strength and good resistance to weathering, ageing and chemicals. Unfortunately, the low-energy ABS cannot be glued completely without problems with common adhesives and usually this is only possible after a surface treatment with the solvent methyl isobutyl ketone. However, ABS with ABS can also be bonded with methyl ethyl ketone (MEK) / butanone and dichloromethane (methylene chloride). Optimum procedure: Clean bonding surfaces, dry. Apply one coat of adhesive to one or both sides and allow to flash off briefly before pressing together. Further information.

Specifically designed to bond Plasticised PVC sheeting and rubberised materials, Suitable for bonding all plastics. Glass Clear UHB Acrylic Tape Short-term temperature tolerance up to 260 °C, with an operating temperature tolerance of up to 150 °C The cold-crosslinking HTV silicone rubbers are plastically deformable materials which are used, for example, as cable sheathing, for electrical insulation or for sealing and damping purposes. The transparent plastic SAN from the group of styrene-based plastics is often used as a material for greenhouse or industrial glazing as well as shower cabins because of its weather resistance, rigidity and scratch resistance. Depending on the requirements, a wide range of high-performance adhesives is suitable for material bonding. Further information. The tape is typically applied during the body in white process. It is run through the automotive paint pre treatment process and then the e coat process. The tape expands and cures in the e coat cure oven to fill and seal small gaps. The tape forms a continuous barrier between similar and dissimilar materials, which minimizes electrical conductivity and helps prevent galvanic interactions.VHB™ Tape permanently adheres one substrate to another and spreads the stress load across the entire length of the joint

Rubber or rubber-like materials are widely used in industry and everyday life: for example in seals and rollers, in vibration dampers or for footwear. In general, a whole range of different types of adhesives are suitable for bonding rubber. However, the optimum adhesive always depends heavily on the rubber compound and the intended use. Further information. Silicones, with their low-energy, extremely repellent surfaces, are considered to be difficult or almost impossible to bond. Among the few adhesive products that show usable results here are, for example, new types of silicone transfer adhesives that, in combination with adhesive tapes, even enable efficient automation of series production processes - for example in the automotive sector. Further information.

Custom

PP - Polyethylene has become an indispensable part of everyday life. It can be found in pipes, rain barrels, dishwashers and a multitude of industrial components, among other things. However, bonding the material is not without problems due to its repellent surface properties. However, efficient adhesive systems on the market today offer practicable solutions for this. Further information. In contrast, the low-viscosity, hot-crosslinked silicone rubber (RTV/NV) is medium-elastic, has good flowability and low viscosity. It is therefore particularly suitable for the manufacture of elastic wax or relief casting moulds, casting moulds for figures or decorative panels, moulds for casting with epoxy / casting resin, cement, plaster or other flowable materials.